You can import tasks from your console to MyEasyFarm. To do this, export the completed job from your console as a zip file. Once you have done this, there are two ways to go about it. The first is to go to your dashboard (or to the 'tasks' tab of a plot) and click on 'Import ISOBUS'.

The second is to go to the active tasks tab of your dashboard and then to "Add tasks". Then fill in "Import a task from an ISOBUS file" and "The task is not in a technical route". Finally, define the type of operation, click on "Continue" and on "Import ISOBUS".

You are now at the same point with regard to both methods. Select the ZIP file you have retrieved from your console and click 'Continue'.

On the right hand side of the page below, match all the fields. If any of the data does not exist in your account, add it by clicking on the green button on the right of the list, otherwise select your data and click on "Match". After each step, click on "Next" at the bottom left.

Once on the page below, check on the right hand side, all the information before clicking on the top right hand side on "Import a task.

NB: If a box is highlighted in red, it is incomplete and must be completed. If you cannot click on "Import a task", look on the left side of the button, you will be shown the missing data.

 Once your task is in the form, as below, click on "Next" at the bottom left. In the same way, continue the following operations until you reach the "Done" button, in the same place.

Your task will normally arrive in the "Pending Approval" box, you will only have to click in "Action", then you will have the choice to either "Reopen the task" and modify the data, or to click on "Finish the task".